2/2 solenoid valves
Positively controlled
Closed in a de-energized state
Fields of application:
2/2 way solenoid valves of the series 43 can be used in closed circuits since the valves work...
Related products
2/2 solenoid valves
Positively controlled
Closed in a de-energized state
Fields of application:
2/2 way solenoid valves of the series 43 can be used in closed circuits since the valves work without a pressure difference because of the
positively controlled diaphragm. Typical fields of application are HVAC and general mechanical engineering.
Type of protection IP65. Installation only with upright magnets!
Delivered with connector plug.
Solenoid coils 012 / T012
012/T012 coils correspond to VDE 0580.
Power consumption: approx. 43/24 VA
Rel. duty time: 100 %
Operating voltage: +5 / -10 %
Possible coil voltages:
24 V =, 24 V, 42 V, 230 V ~ (50 Hz + 60 Hz)
Media: Air, water, neutral gases
Temperature: -10 - +90°C
Seal material: NBR
Media: Water, hot water, vapour
Temperature: -10 - +130°C
Seal material: EPDM design-TM
Media: Oil (also synthetic), fuel
Temperature: -10 - +100°C
Seal material: FKM
Ambient temperature: -10°C / +35°C
Viscosity: max. 22 mm²/s-1
Burst pressure: > 60 bar
| Scope of delivery: | |||
| 1 x | solenoid valve | ||
| 1 x | appliance plug | ||
For more information see Downloads
| OEG no. | 113123450 |
| Model: | Normally closed (NC) |
| Housing: | Brass 2.0402 |
| Voltage [V]: | 230V / 50Hz |
| Connection: | 1/2" |
| Protection type [IP]: |
 IP65 
|
| kv-value: | 3.9 m³/h |
| Ambient temperature [°C]: | -10 .. 50 |
| Power consumption [W]: | 18 |
| Viscosity: | Max. 22 mm²/s-1 |
| Seal: | NBR |
| Pressure [bar]: | 0 - 16 |
| Media temperature [°C]: | -10 .. 80 |
| Weight [kg] | 0.68 |
| Customs tariff number | 84818087 |
bonjour ,cette électrovanne peut elle servir pour la supression d'un compresseur merci
Bonjour,
Oui, l'électrovanne peut commuter une plage de pression de -0,9 à 16 bar, c'est-à-dire également du vide jusqu'à -0,9 bar.
"Einbau nur mit stehenden Magneten" was bedeutet das? Vertikal / Horizontal?
Guten Morgen,
der Einbau des Magnetventils darf lediglich horizontal (wagerecht) erfolgen.
You have to be logged in to ask a question
23/01/2017, 14:47:11 of: Mr Feld
gut
Der Einbau des Magnetventil von GSR sehr einfach
